Transmission Manuals – All data about Transmission

P0717  Turbine Speed Sensor Circuit No Signal  

Descriotion:
This sensor detects the rotation speed of the turbine which shows the input revolution of the transmission. By comparing the input turbine speed signal NT with the counter gear speed sensor signal SP2, the ECM detects the shift timing of the gears and appropriately controls the engine torque and hydraulic pressure according to various conditions and as a result, the gears shift smoothly.

DTC CodeDTC Detection ConditionTrouble Area
P0717All conditions below are detected for 5 seconds or more (1-trip detection logic)
(a) Gear change is not performed
(b) Gear position: 4th, 5th or 6th
(c) T/M input shaft rpm: Less than 300 rpm
(d) T/M output shaft rpm: 1000 rpm or more
(e) Park/neutral position switch:
·NSW input signal is OFF·R input signal is OFF
(f) Shift solenoid valves and park/neutral position switch are operating normally
·Open or short in speed sensor NT circuit·Speed sensor NT·ECM·Automatic transmission (clutch, brake or gear, etc.)

Typical enabling conditions:

The monitor will run whenever the following DTCs are not presentP0705 (Park/neutral position switch circuit)
P0751, P0973, P0974 (Shift solenoid valve S1)
P0756, P0976, P0977 (Shift solenoid valve S2)
P0761, P0979, P0980 (Shift solenoid valve S3)
P0766, P0982, P0983 (Shift solenoid valve S4)
P0748 (Shift solenoid valve SL1 circuit)
P0776, P0778 (Shift solenoid valve SL2)
Shift changeAfter shift change is completed and before starting next shift change operation
ECM selected gear4th, 5th or 6th
Output shaft rpm1000 rpm or more
NSW switchOFF
R switchOFF
EngineRunning
Battery voltage8 V or more
Ignition switchON
StarterOFF

Wiring diagram P0717:

Data list:

Tester DisplayMeasurement Item/RangeNormal ConditionDiagnostic Note
SPD (NT)Input shaft speed/
Min.: 0 rpm
Max.: 12750 rpm
Lock-up is:
·ON (after warming up engine): Input turbine speed (NT) is equal to engine speed·OFF (idling with shift lever on N): Input turbine speed (NT) is nearly equal to engine speed
Data is displayed in increments of 50 rpm

Procedure:
1. Inspect speed sensor NT installation

Check the speed sensor NT installation? OK >> The isntallation bolt is tightened is no clearance between the sensor and transmission case.

2. Inspect speed sensor NT.

a. Disconnect the D65 speed sensor connector.

b. Measure the resistance according to the value(S) in the table below.

Tester ConnectionConditionSpecified Condition
1 – 220°C (68°F)560 to 680 Ω

3. Check harness and connector (speed sensor NT – ECM)

a. Disconnect the D47 ECM connector.

b. Measure the resistance according to the value(s) in the table below.

Tester ConnectionConditionSpecified Condition
D74-124 (NT+) – D74-123 (NT-)20°C (68°F)560 to 680 Ω
D74-124 (NT+) – Body groundAlways10 kΩ or higher
D74-123 (NT-) – Body groundAlways10 kΩ or higher
ResultProceed to
NGA
OK B

NG: Repair or replace harness of connector.
OK: Replace ECM.

https://www.toyotaworkshop.com/Toyota/Tundra/n00214/N00214/manual/repair/img/png/U152235E02.png